hi im looking for a post processor for a mach 3 controller to work with edgecam, ive had a few suggestions on how to do this but im really not sure on how to compile g code etc. im at university and if i could get a post processor i could use a newly purchased milling machine intead of using the workshop. ive been told that in edgecam the post processors Fanuc 6 and Fanuc 11 are similar to a mach3 post processor?? is this true. on our edgecam we only have
Fanuc3x-in.mcp
Fanuc3x.mcp
Fanucab-in.mcp
Fanucab.mcp
Fanucba.mcp
Fanucbc.mcp
thanks very much!