Hello everyone. I'm a long time lurker and first time poster. I work for the University of Pittsburgh doing medical R&D. My shop has two Bridgeport Ezvision knee mills and a Hardinge GS-150 lathe. We also have all the normal machine shop equipment.

So now my question. Is there any way to make a back-up of the compact flash card that the new EZVision controls use to run the system?

When my mills were installed 2 years ago and machine #1 had a card problem. It was replaced under warranty and now some 20 months later it has gone again. But this time it isn't under warranty and I'm being told there is no way to back it up because it is protected.

So does anyone have any experience with this?


Thanks
Travis