Where is the adjustment to let Mach3 know what my cutting table size is ?
When I post my G-code from LazyCam, it only shows and cuts part of my drawing, even if I scale down my part very small. (What is the problem?)
Craig
Where is the adjustment to let Mach3 know what my cutting table size is ?
When I post my G-code from LazyCam, it only shows and cuts part of my drawing, even if I scale down my part very small. (What is the problem?)
Craig
I think the demo of LazyCAM is limited in how many lines of g-code it produces. What your seeing has nothing to do with table size. The only thing in Mach3 that's similar to setting a table size is Soft Limits.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thank You