Hard to believe I cut my first part one year ago today.
I thought I'd post about the newest project. The machine is running while I type this.
This the initial concept for a light. On the left is a screen capture of of some of the tool paths I ran today. I will continue to update www.grunblau.com
This was the first step, I cut out the 2D shapes and glued them to the layer underneath. Front shapes are roughed in and ready for the finish pass.
Finish pass.
Detail taken between the rough step and the finish step.
I then flipped the piece over and ran the rough pass for the rear.
Finish pass for the rear.
I took the top layer off and began the rough pass for the interior.
Finish pass for the interior.
That's it for today! This weekend was the first time I had two days off in a row for almost four months!