Hi everyone,having recieved many customers' advice ,we made some improvment on NM-200 for customers' ease.such as:
The covers of the coupling for the Z axis motor are standard and the same so that each machine can use the same one.
To prevent rubbing between the bars of the Interface Module and the Electrical cabinet, we placed a washer(2mm thick) between the top two bars of the electrical cabinet system.
For customers' opening the crate, the one side closest to the electrical cabinet will have screws on all sides to allow removing the single panel, and the remaining portion of the crate will have screws on the lowers sides in order to remove it horizontally from the skid.
Because the blocks on the chip tray always move when installing the mill onto the chip tray, the four round and two square blocks were welded onto the chip tray so that it will be easier for customers to assemble.
AND SO ON
It's all some details,and we really care a lot for customers.