Hello. I need some help with G71 programming on a fanuc OI control. I understand there are two types of G71 and I would like some explanations about how to use both types .Thanks.
Hello. I need some help with G71 programming on a fanuc OI control. I understand there are two types of G71 and I would like some explanations about how to use both types .Thanks.
A G71 Type I finish profile must have monotonous increases in X-axis. G71 Type II allows up to 4 valleys (in X) within the finish profile. In both cases Z must be monotonous.
G71 Type I is designated by a single axis move in the P block:
G71 P101 Q101
G00 X1.5
G71 Type II is designated by a 2 axis move in the P block.
G71 P101 Q102
G00 X1.5 Z0.1