Help. I have a vmc 15 xt which worked ok
When i today started it i got severel alarms when doing the cs procedure
I have alarms on both the x and y axis. most of the times alarm nr 18 but also sometimes nr 1 or 3. Sometimes it even says alarm on all the 3 axis??
I swapped the z-amplifier card to the x and y positions and the problem was going with the card. So normally i got 2 broken amplifiers. My question is": is it possible to have 2 cards broken in one second or is there an other problem.
I also swapped the axis-boards but then i have the same problem.

Thanks for your help
Kees from holland