[macrob5482]

Hi,

I have a Doosan 6030 Revo Mecatec mill with a Fanuc 0m control. I have a project that requires broaching a slot in the cylinder. Does anyone know how to get around the safety in the machine that prevents the axis from moving in Feed mode with the spindle off?

I am trying to move the Z and X axis in Feedrate mode with the spindle locked in the orient position...Built in safety prevents me from doing this...

Thanks,
Richard

[dcoupar]

M84 allows feeding with the spindle stopped. M85 cancels M84.

[macrob5482]

Tried that command...In our machine, M84 relates to the ATC...M59 needs to be use, then it wants to check for a pot down position.

I've had to do this on other machines and it was a change in one of the parameters, but I can't find my notes to apply it on this machine.... Anyone else have any ideas on how I can do this? It's light broaching, so I figured if I can set the tool up, orient the spindle and set the tool manually so it's in the right direction I could get it done without removing the part and doing it as a secondary op.......

Thanks!

[dcoupar]

Sorry, M84 works on the newer Daewoo/Doosan mills.

[MysticMonkey]

Try

M184 = Axis Moving Valid when Spindle Stop
M185 = Axis Moving Invalid when Spindle Stop

[tizm]

if your just doin light broaching, you can orient spindle-m19.then use rapid instead of a feedrate! just put rapid down to 25%!

[MysticMonkey]

if your just doin light broaching, you can orient spindle-m19.then use rapid instead of a feedrate! just put rapid down to 25%!

Im fairly certain you cannot G00 if you cannot G01

[tizm]

You can on a doosan , haas , supermax!other machines i dont know!