I have read that tuning a Rutex is easier since they have tuning
software and that you have to have a osciliscope to properly
tune a Gecko. Is this true? How does one tune a G340 without
a scope? Is it easy?, or is it just trial and error and hope you
get something that works ok, or can you tune motor accuratly
without one???
Thread: Tuning a G340 servo drive
Results 1 to 2 of 2
-
04-07-2005, 06:34 AM #1
Registered
- Join Date
- Jul 2004
- Posts
- 83
Tuning a G340 servo drive
-
04-07-2005, 01:15 PM #2
Registered
- Join Date
- Feb 2004
- Posts
- 56
Hey,
Most accurate with an o-scope. However, the drives come preset for 'most' motors. So you may not have to mess with them at all. On the other hand, it's not rocket science to tune them by eye. Don't sweat it.
Reply With QuoteSimilar Threads
-
Using surplus servo motors as spindle drive
By Swede in forum Servo Motors / DrivesReplies: 11Last Post: 03-16-2008, 02:05 PM -
Driving a 4 pole ac servo with a 6 pole drive
By TommyB in forum Servo Motors / DrivesReplies: 4Last Post: 04-28-2005, 07:17 PM -
Where can I find Detail Specs Servo & Drive MEans ?
By Calico in forum Servo Motors / DrivesReplies: 1Last Post: 02-28-2005, 06:37 PM -
Anyone with experience tuning a Compax servo drive?
By ESjaavik in forum Servo Motors / DrivesReplies: 0Last Post: 08-14-2004, 12:33 AM -
R90H Servo Drive
By Verboten in forum Servo DrivesReplies: 16Last Post: 03-31-2004, 04:10 AM
Posting Permissions
