Is there a way to convert a circle that is made of very short lines into a proper curve or circle ?
Is there a way to convert a circle that is made of very short lines into a proper curve or circle ?
I dont think so.
You will just have to manually snap a circle onto it and delete the line segments.
www.integratedmechanical.ca
What about selecting the lines and under Tool/Spline Tools choose Fit Spline?
Havoc
That works but it gives you a spline, not a circle
www.integratedmechanical.ca
Yep
Take the end points or the mid points or both and plug them into this.
http://www.mathworks.com/matlabcentr...eexchange/5557