[Hopefully this is the right forum. Holy cow there are a lot of sub-forums!]
I have an old wells index w/ a bandit controller that fried. It has 1600oz nema 42's, 3-axis.
Any recommendations for a complete (ideally already assembled) kit for a retrofit? I'm hoping to rip off the electronics and old motors and bolt on new ones then go.
Keling CNC seems to have a reasonable kit for ~$1500. The other places I've looked at are either a lot more, or seem to be based in asia, where support would be iffy.
Larkin has a already built controller, but I think I'd need to get $2,400: Larken Stepper Motor control products