I'm looking for a quote of 1,000 and 2,000 pieces.
I'm looking for a quote of 1,000 and 2,000 pieces.
HI DEAR ,
PLEASE GIVE ME A DAY TO QUOTE . I WILL QUOTE CONSIDERING MOULD CHARGES . YOU PLEASE GIVE ME YOUR E MAIL ID . MY E MAIL ID IS [email protected]
cheers ,
shailesh sheorey
spectrum plastics
NAGPUR CITY ,
INDIA
are you looking to have these molded?
I am looking to have this part machined. I am also only interested in US quotes.
i could get a mold quoted for you and it would be done in the usa penna.
probably would be more cost effective.
just let me know.
I am open to different ideas, but know that this is a one time job.
ok i'll ask for the quote and see what happens.
What is your finish and flatness call out? If done the cheapest way in one op the face will have feed lines and probably be concave.
PM sent
Mactec54
quote sent via private msg parts will be flat and nice finish. molded.
thanks
Anyone mind sharing the tooling cost for a mold? It of course will need to be multiple cavity. Molding will look better than machining but at these quantities I would think it would make the per piece price too expensive, unless it went to China. Even if the mold cost $500 machining will beat the price on 1,000 pieces. You also have +\- .0005 on a diameter, I would think the mold would have to be dead on to hold that.
Dualkit
Mold cost up to $150
Mactec54
to build the tool and mold 2000 pcs the piece price would work out to 1.28 a piece all said and done.
Thanks to everyone who replied. Job has been awarded to a shop in PA.
could you be kind enough to tell us what piece price you got them for?
Once he announced the state (PA), it probably would not be cool to list the price as everybody jumps on the low bidder lately. Polypropylene is too hard to turn burr free in that sized part. I gave him a bar fed price on Delrin at 90 cents, I am assuming the final price was less than that.
Dualkit
I priced it at 32cents molded for 2000 parts, I could of gone a little lower
Mactec54