586,103 active members*
3,959 visitors online*
Register for free
Login

Thread: Stainless Steel

Results 1 to 3 of 3
  1. 02-09-2010, 04:05 PM #1
    waterfxmatt
    waterfxmatt is offline Registered
    Join Date
    Feb 2010
    Posts
    0

    Stainless Steel

    Can I get a little help with some settings for Stainless Steel 10 and 12 ga?

    I am using the 40amp fine cut consumables....Hypertherm 1650 set at 45 amps. getting a real ragged cut with lots of slag. Very sure it is a simple adjustment to make this better.

    Thanks!
    Reply With Quote Reply With Quote
  2. 02-09-2010, 07:59 PM #2
    Bigrhamr
    Bigrhamr is offline Registered
    Join Date
    Dec 2009
    Posts
    35
    I can't offer any real help other than saying go by the settings in your 1650 manual but if you post this down in the Hypertherm forum Jim Colt from Hypertherm will be all over it and get you dialed in quick.
    Reply With Quote Reply With Quote
  3. 02-09-2010, 08:00 PM #3
    waterfxmatt
    waterfxmatt is offline Registered
    Join Date
    Feb 2010
    Posts
    0
    Thanks...will do.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 303 vs. 304 stainless steel
    By pearldiver in forum MetalWork Discussion
    Replies: 2
    Last Post: 02-06-2020, 08:45 AM
  2. Stainless Steel
    By jdclark in forum Shopmaster/Shoptask
    Replies: 2
    Last Post: 02-25-2009, 05:08 AM
  3. Steel or Stainless
    By tool_man in forum Casting Metals
    Replies: 2
    Last Post: 10-29-2006, 12:46 PM
  4. Stainless Or Steel
    By 69owb in forum Mechanical Calculations/Engineering Design
    Replies: 5
    Last Post: 10-03-2006, 07:43 PM
  5. Is stainless steel
    By cncadmin in forum Hard / High Speed Machining
    Replies: 12
    Last Post: 10-17-2003, 02:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules