534,964 active members*
2,538 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Gecko Drives > 10 Best CNC Controllers????
Results 1 to 2 of 2
  1. #1
    Registered
    Join Date
    May 2006
    Posts
    264

    10 Best CNC Controllers????

    Can these cheap drivers give the same good performance as a Gecko?

    https://theedgecutter.com/best-cnc-controllers/

  2. #2
    Registered
    Join Date
    May 2015
    Posts
    549

    Re: 10 Best CNC Controllers????

    Personally I think Gecko are over priced and rely on yesterdays reputation. There are much better controllers but I found Longs Motors DM542a drivers were equally as good and supported 25x microstepping which worked well for me until I upgraded to Lam Technology DS1076a drivers which leave Gecko for dead!
    Rod Webster
    www.vehiclemods.net.au

Similar Threads

  1. Replies: 1
    Last Post: 01-04-2013, 04:45 AM
  2. Controllers
    By paulstenlund in forum DIY CNC Router Table Machines
    Replies: 0
    Last Post: 04-16-2009, 12:21 AM
  3. DIY Controllers
    By biotech1 in forum Mechanical Calculations/Engineering Design
    Replies: 2
    Last Post: 12-02-2006, 11:56 AM
  4. pic controllers
    By DrStein99 in forum PIC Programing / Design
    Replies: 2
    Last Post: 01-17-2006, 07:00 PM
  5. Controllers which?
    By drakesis in forum Stepper Motors / Drives
    Replies: 9
    Last Post: 04-04-2005, 11:35 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •