587,982 active members*
4,098 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Gecko Drives > 320 ERR/RES wiring diagram
Results 1 to 3 of 3
  1. #1
    Join Date
    Jun 2009
    Posts
    52

    320 ERR/RES wiring diagram

    I would like to have my reset button for the err/res running now that everything is up and running. So far I have just connected terminal #5 and #7 so that it allways restarts if a problem occurs. Please let me know if this wirrering is correct so that I don´t burn any of them, plus that I get all my gecko 320 drivers to "fault" if only one faults. I would like this to happen so that all axes stops and my part does not get broken.
    I know that daesy chaining is not allowed, but in this case where I wan´t all the drivers to stop, it is the only way I can see it being done. Please let me know how to do this. Thanks
    Attached Thumbnails Attached Thumbnails err_res_G320.jpg  

  2. #2
    Join Date
    Jun 2009
    Posts
    52
    Has no one got an answer

  3. #3
    Join Date
    Jun 2009
    Posts
    52

    Smile

    For everyone attention. The below drawing was confirmed by Gecko on how to do it.

    Kim

Similar Threads

  1. WIRING DIAGRAM FOR NEW SX3
    By Crevice Reamer in forum Syil Products
    Replies: 11
    Last Post: 04-29-2009, 04:40 PM
  2. Wiring diagram
    By jdmyers in forum Bridgeport / Hardinge Mills
    Replies: 6
    Last Post: 11-03-2008, 11:25 AM
  3. help with wiring diagram for C6 CNC
    By JDsto in forum Syil Products
    Replies: 6
    Last Post: 01-10-2008, 01:37 AM
  4. Wiring Diagram
    By SCHMEOW in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 10-21-2007, 05:40 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •