[AKFALAR]

I have two AD sureservo drives and i really would like to drive two with one signal (i posted on another thread about that) however as a plan B i guess i need to get a third axis and tie two of them together.

I'm retrofitting a gantry where a shaft now allow one servo to drive it. Im going to two drives for the axis.


Anyhow, how does one get the two axis to act as one? I have been oven the documentation and i must have missed it...

Thanks i advance...

[Karl_T]

Are you using a Galil card? Most Camsoft controls do.

I just did a project where I slaved the Z axis to the spindle for threading. Not what you're doing but I remember reading a fair bit about your project researching mine.

There's a lot of info in the galil manuals. And a fair bit more in Camsoft's manual. Its all there but you'll have to search a bit.

In general you connect each servo, encoder,drive etc. to its own axis. Then tell camsoft and galil these two are slaved.

Karl

[Al_The_Man]

If it is for the Galil card, go to the Galil site and look at the animated examples, they will show the commands used such as GA gearing command.
Al.

[AKFALAR]

I slaved the two amps and fed the master amp the signal i wanted.

Worked nicely.

SureSERVO is cool its just a pain at first.