We have a BP Interac 2 with a Heidenhain TNC151 control. We have the opportunity to purchase a BP Interac 1 with a TNC2500 control at scrap
price. Can anyone tell me if any of the electrical components will interchange
between the two?(Monitor,Drive cards,etc....)
Thread: BP Interac 1 And BP Interac 2
Results 1 to 5 of 5
-
11-04-2008, 06:40 PM #1
Registered
- Join Date
- Oct 2006
- Posts
- 7
BP Interac 1 And BP Interac 2
-
11-04-2008, 10:51 PM #2
Moderator
- Join Date
- Nov 2004
- Posts
- 3028
Motors, drives are stronger on the Interact 2.
Controls are different.
Not much from the donor except head parts, 24VDC power supplies.
George(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
11-05-2008, 02:14 PM #3
Registered
- Join Date
- Oct 2006
- Posts
- 7
Thanks for the information Machinetek. I appreciate it very much. You did
not mention the monitor. Do you think it may be compatible? If it is, it
would make the purchase worth doing, just for it alone.
-
11-20-2008, 02:51 AM #4
Registered
- Join Date
- Jul 2008
- Posts
- 56
you didn't say whether it was a MK1 or M2, if it is a MK2 could you please find out if it has an intact MTI-1 spindle drive card, I desperately need one, thanks Brian
-
11-20-2008, 03:24 AM #5
Moderator
- Join Date
- Nov 2004
- Posts
- 3028
Monitors are different.
George(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With Quote
Posting Permissions
