Looking for Much needed help: I have a New Chinese 50 W By RayLaser running NewlyDrawn 2.0 on an XP computer through UBS with 2 Gig nothing else on it accept NewlyDraw 1.5. We had fits with the laser for months ( I still think it the driver). Finally, we loaded it onto a completely clean XP without Service Packs 3 loaded. I t appears to run fine with 1 & 2, but somehow conflicts with SP3 WE THINK ???. We have another with CorelDraw X6 64 bit running on another XP with SP3 and need to somehow network these 2 units. I tried a USB cable and a Cat 5 with a net gear switch and cables but was not able to get them to work. Does anybody if both computer need all three service packs to work ??. How else could I do this? Could I partition the hard drive so that one has SP3 and the other doesn’t? I also have an external hard drive I could use. Any help will be greatly received.