Other controls such as the one above has fill in the blank setup capability, very user friendly after reading the manual,. No programming required.. servos self tune through the software, than just regular distance setup per axis... For the ATC, there's a series of steps to setup head height and tool pallet height etc very simple and done right through the control interface.
If pathpilot was within my scope of programming I would have a stronger case for sticking it out with Linuxcnc, but I just have not done anything yo date with it because of the controls and know myself enough that it will go another year if I'm stuck having to learn programming in Linux.
Big investment being held up by a smaller investment...lol. My father always says don't let a dime hold up a dollar . This case fits that bill..
Sent from my XT1585 using Tapatalk