Currently building a CNC Router, 40" x 30" working area. Ordered a package from KelingInc , Acme 1/2 10 2 start lead screw from McMaster and Dumpster backlash nuts. Using an old computer case to hold electronics. Also going to run with Mach3. This is my first time at building one but I am sure am enjoying it.
In the photo's you might notice that I am using 4 wire trailer disconnect to go to the stepper motors. I wanted some way to quick disconnect from the electronics. Has anyone used this method before or is there anything I should be concerned about?
Any comments, good or bad are welcome..............Thanks, Tom
http://www.bennion.net/router/index.html
Thread: CNC Router - Foam/Wood Working
Results 1 to 1 of 1
-
03-16-2008, 11:17 PM #1
Registered
- Join Date
- Feb 2008
- Posts
- 1
CNC Router - Foam/Wood Working
Reply With QuoteSimilar Threads
-
Foam & Wood milling machine
By perolalars in forum DIY CNC Router Table MachinesReplies: 0Last Post: 04-11-2007, 05:42 PM -
I am looking to buy a router. Working or not.
By runinbymdnt in forum DIY CNC Router Table MachinesReplies: 1Last Post: 12-30-2006, 03:46 PM -
Foam router
By KrashKing405 in forum CNC Wire Foam Cutter MachinesReplies: 0Last Post: 12-26-2006, 12:51 AM -
Looking for cutting speed and feerate data in wood and foam
By Trimix in forum DIY CNC Router Table MachinesReplies: 1Last Post: 01-21-2004, 03:20 AM -
WOOD WORKING SHOW IN CALI
By cadcam in forum Trade Shows / Webinars / Other EventsReplies: 1Last Post: 07-08-2003, 07:08 PM
Posting Permissions
