[webcruiser8]

We have the following products:

Servo CNC table and controller, 4'x4', 4'x8' and 5'x10', 6'x12'
2 and half axis. X-Y is fully CNC control. Z is manual control, 6 inch in Z-axis.
stainless steel water tank
Max control accuracy +/-0.01mm (0.0004").
Positioning repeatability accuracy +/-0.05mm (0.002")
Max travel speed 10m/min (33')
http://www.iwmwaterjet.com
http://www.waterjet-cutter.com

[Switcher]

The machine looks great!

I don't mean to be rude, but I'm a bit confused. In your other post you say

good source of CNC 101

--------------------------------------------------------------------------------

Hi I am new in CNC. Just wonder if some one could point out a few good
sources for me to start with. I try to read the posts there, but quickly
get lost with the terms such as ball screws, pinion, backlash........

Many many thanks for your guidence.

And in this post it sounds like you are selling a waterjet cnc.

Again this isn't meant to be rude.


Jerry




.

[webcruiser8]

Just let me clear the water. I am helping to sell this waterjet machine.
But I AM new in this CNC area. I did not make that machine in picture,
and hope someday I can. I am ok with waterjet pumps, but not
CNC. To improve, I am starting to learn both CNC hardware and software.
It is like a black box to me right now.