I purchased the CT model 2329 servo drive on Ebay and was wondering if anybody is familiar with how these units work? I know that they use a +10 and -10 volt for direction control but that is all I am able to find out about them. There is only command and enable inputs on them. how can I use these with feedback? If I am unable to use them with a cnc router then at least I have a good power supply as they have a dual coil 24v toroid transformer in them with rectifier and cap. series output is 77v so I guess that parallel would be around 38v. Any suggestions?
Tom
Results 1 to 2 of 2
-
04-17-2004, 04:31 AM #1
Registered
- Join Date
- Nov 2003
- Posts
- 244
Control Technology Corp. Servo drives
-
04-18-2004, 02:59 AM #2
Registered
- Join Date
- Nov 2003
- Posts
- 244
Finally found out that they require an adapter card for positional analog feedback, guess I have my power supplies for my gecko's.
Found out Rutex has a step direction driver for these .
Reply With QuoteSimilar Threads
-
What servo drives use resolver inputs?
By murphy625 in forum Servo Motors / DrivesReplies: 3Last Post: 03-15-2005, 07:28 PM -
Servo control software
By gareth in forum Servo Motors / DrivesReplies: 0Last Post: 02-05-2005, 02:17 AM -
Need input for servo control systems
By cncadmin in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 01-31-2005, 05:45 PM -
steppers or servo drives
By mmjpotter in forum Gecko DrivesReplies: 14Last Post: 03-30-2004, 09:56 PM -
Some Servo Control Questions
By Noah in forum CNC Machine Related ElectronicsReplies: 5Last Post: 03-02-2004, 05:41 AM
Posting Permissions
