[len]

I went to deskcnc.com website and they have a new version of deskcnc v2.0.0.94 but when I download it and install it, the verison is v2.0.0.92 an I missing somthing?:drowning:

Also estop and limit has to be grounded for the software to operate, why is this, the old board did not need this. :drowning:

[imserv]

Also estop and limit has to be grounded for the software to operate, why is this, the old board did not need this. :drowning:

Estop has always been required to operate the board. At about the same time the 2nd generation board was released the 1st gen was updated to permit this as an option.

lim does not have to be grounded if you disable the probe.

Support for DeskCNC software and hardware is at:
http://www.imsrv.com/discus


Fred Smith - IMService
http://www.cadcamcadcam.com/hobby

[cncadmin]

Len, their is a new version of the software on deskcnc.com, after you install it re-start your machine and than it seams to upgrade it and than it will work right.