[ddragon]

Hi
Hopefully someone can help. I think this is a pretty common conversion. So if someone could send me their settings I would appreciate it.

I'm setting up a ct129 cnc conversion using the Keling products.

But I need the dip switch settings for the DL-5056D with two nema 23 and one nema 34 stepper. I'm also using the c10 board.

Thanks

[hoss2006]

What microstepping do you have the jumpers set to?
200 (steps rev of stepper) x 10 (screw tpi) x 2 (1/2 micro stepping) = 4000 steps per in motor tuning.
setting the jumpers as follows will be for 1/2 microstepping
1-off (on if you want max current)
2-on
3-on
4-on (gives half idle current for cooler steppers)
5-off
6-on
7-on
8-on
Hoss

read more here.
http://www.g0704.com/G0704_electronics.html#wiring

[ddragon]

Actually I haven't gotten that far. Still need to setup Mach 3. I'm wiring it right now.
But thank you. I'll go over the link you sent as well.