535,108 active members*
2,872 visitors online*
Register for free
IndustryArena Forum > MetalWorking Machines > Daewoo/Doosan > doosan lynx 2100 lsya turret unclamped
Results 1 to 3 of 3
  1. #1
    Join Date
    Feb 2011

    doosan lynx 2100 lsya turret unclamped

    I have a new (2020) doosan lynx 2100 lsya

    i had a tool sticking out to far toward the sub spindle and when it went to clamp it couldn't
    the tool has been removed so there is no interferance
    but still have the following alarms
    2146 servo drive overheat
    2118 turret clamp/ unclamp
    does anyone know of the procedure to reset the machine

  2. #2
    Join Date
    Feb 2013

    Re: doosan lynx 2100 lsya turret unclamped

    Call my cell. (973) 803-9479
    Doosan Service Technician
    darryl.hardt@doosanmt.com O:973-618-2461 M:973-803-9479

  3. #3
    Join Date
    Feb 2011

    Re: doosan lynx 2100 lsya turret unclamped

    dhardt thanks for the opportunity to give you a call i appreciate it very much
    able machine got back to me and did a good job of helping me out

    1st attempt was E stop then try and move the turret by hand
    2nd attempt was change a keep relay to activate the turret to un-clamp move the turret sightly and re clamp the turret this worked very well

Similar Threads

  1. Doosan Lynx 300 Turret alignment
    By Ally369 in forum Turning
    Replies: 0
    Last Post: 08-23-2019, 06:35 PM
  2. Doosan lynx lm 220
    By Unregistered in forum Daewoo/Doosan
    Replies: 0
    Last Post: 12-18-2017, 09:28 AM
  3. lynx doosan 220
    By tpsimer in forum General MetalWork Discussion
    Replies: 0
    Last Post: 02-08-2014, 06:27 PM
  4. Duplomatic 300 turret unclamped
    By dbarath in forum Colchester Tornado lathes
    Replies: 6
    Last Post: 05-07-2011, 10:53 PM
  5. Doosan Lynx 220 Gang Tool or Turret?
    By abhthree in forum Daewoo/Doosan
    Replies: 1
    Last Post: 10-22-2010, 02:56 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts