when we restart a program in eia on a Mazak nexus 640m, we don't have a feed rate. The only feed rate is the manual feedrate and i am not sure where the machine is going. we restart at the tool change. any idea?
Results 1 to 2 of 2
-
01-31-2008, 03:52 AM #1
Registered
- Join Date
- Jul 2007
- Posts
- 25
eia restart problem on mazak nexus 640m mill
-
02-04-2008, 03:58 PM #2
Registered
- Join Date
- Mar 2005
- Posts
- 988
Post your code. .....
But anytime you restart a machine, you need certain codes read so that the machine will do what you want. No different than when you start a program from the top. In this case, you either have a G1(2/3) with no feed, a positioning commmand with no G0, or a G1(2/3) with no feed.It's just a part..... cutter still goes round and round....
Reply With QuoteSimilar Threads
-
Mazak Nexus 510
By jamie pinols in forum Uncategorised MetalWorking MachinesReplies: 3Last Post: 08-21-2009, 05:19 AM -
post for mazak 640 m Nexus with Pro-E
By plast-art in forum Mazak, Mitsubishi, MazatrolReplies: 4Last Post: 01-01-2009, 10:29 PM -
turn on part counter in eia on MAZAK nexus vertical mill
By Denis13 in forum Mazak, Mitsubishi, MazatrolReplies: 0Last Post: 01-31-2008, 03:49 AM -
mazak 640m circular tornado milling cycle
By magneto259 in forum Mazak, Mitsubishi, MazatrolReplies: 5Last Post: 04-20-2007, 06:03 PM -
need post processor for mazak 640m nexus controller
By Rcky123 in forum Mazak, Mitsubishi, MazatrolReplies: 3Last Post: 04-06-2007, 08:23 PM
Posting Permissions
