any one ever get a error message when chaining geometry for a rough flowline on filleted surfaces?
any idea where to start looking?
thank you
tim
Thread: error message flowline conflict?
Results 1 to 1 of 1
-
12-22-2009, 05:44 AM #1
Registered
- Join Date
- Jul 2006
- Posts
- 297
error message flowline conflict?
2007 Haas TMP-1 Microscribe MX-5 Mastercam X4 Mill Level 3 Surfaces,Solids Seagate 2 tb hard drive AMD 64x2 8gig ram windows ultimate 7 64bit Geoforce 8800 GTX
Reply With QuoteSimilar Threads
-
error message
By Claude Boudreau in forum BobCad-CamReplies: 10Last Post: 08-13-2011, 11:39 AM -
Error message CR1 etc.
By NPI in forum Bridgeport / Hardinge MillsReplies: 8Last Post: 09-25-2010, 03:34 AM -
error message during rough flowline or contour
By George777 in forum MastercamReplies: 1Last Post: 12-22-2009, 01:41 AM -
Error Message
By Mastercam User in forum MastercamReplies: 13Last Post: 05-10-2008, 04:31 PM -
G83 error message
By HBFixedGear in forum FadalReplies: 14Last Post: 01-30-2007, 04:42 PM
Posting Permissions
