[bvaught]

While trying to use an older post that works fine on another pc running Esprit 2002, the 2009 version chokes when I try to create nc code. I ran the compiler and it gives numerous error messages. This is a post for a Mits wire edm. Nothing special with the post. I just got tired of going from one pc to another and thought I would get the 2009 machine setup and so far, this is the only problem.

Any thoughts?

Thanks,

Brian

[cbr_speedster]

I may be able to help if you send the post. You can e-mail me direct if you want.

[bvaught]

Thanks for the offer, but I was able to edit a newer one I find to work with my machine.

[thangcadcam]

Dear all,
I setup Sprit 2009 so many times,but not success.
It display "Setup detected that Sentinel drivers version 5 minimum are not installed on this machine.
Please correct and rerun the installation."
Although I setup Sentinel driver 7.40 in my computer.
I knew you setup success.
Please tell me how to solve.
Thank you so much.

[CNC_Technician]

Dear all,
I setup Sprit 2009 so many times,but not success.
It display "Setup detected that Sentinel drivers version 5 minimum are not installed on this machine.
Please correct and rerun the installation."
Although I setup Sentinel driver 7.40 in my computer.
I knew you setup success.
Please tell me how to solve.
Thank you so much.

hi dear you must uninstall the Sentinel drivers version 5 then install Sentinel driver 7.40 .
by the way u need Hardware Squrity.