[bobancurug]

Hi all,

I bought a machine QUASER MK60IIH with system FANUC 18-MC.
I have a problem with stopping x, y and z axes.
When I running one of the three axis in JOG, HANDLE or MEM mode happens delay stopping of all three axes. When release the button in JOG mode, or stop handwheel in HANDLE axis slowly stopped after a few millimeters. The same happens when run the program.
I noticed that the position on the screen immediately stop after the release button or a handwheel axis continues to slow down a few more millimeters.
At the C axis, this problem does not happen, that works without errors
All three axes have fanuc encoder, and Linear encoders for position control.
Does someone can help me where to start with solving this problem.
I tried with certain parameters for the acceleration / deceleration, but nothing has changed.

[bobancurug]

I added the parameters that are currently in the machine, if someone can conclude something from them.

[alexfanuc]

Hello,
Do you have the original parameters? Make a backup of the parameters before you start changing any of them.
If you have the original parameters I would compare 1815 to see if this is correct.
Remember to make a backup before you change any parameters.
I would change parameter N2003 00101000 to 00001000. Just try it for one axis (X) and see what it does.
Regards.
Alex

[bobancurug]

Hi Alex,

I will try today to change this parameter , and here is the original parameters that I received on a floppy disk with the machine.
Some of the parameters in the machine that are different from the original parameters I tried to change but nothing has changed.