Could someone please advise me on post processing for Fanuc 6M to a ProtoTRAK MX2? For some reason, the ProtoTRAK MX2 is not recognizing the data from OneCNC.
Thank you,
Gordonv
Could someone please advise me on post processing for Fanuc 6M to a ProtoTRAK MX2? For some reason, the ProtoTRAK MX2 is not recognizing the data from OneCNC.
Thank you,
Gordonv
Gordonv,
Have you looked on the OneCNC forum?? There are several ProtoTrak posts over there for different models..
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thank you!