G-Zero by Rapid Output!!!!!
Here is one that many of you may not have seen before. I have an OLD DOS Version called EDI that will back plot for Mills, Send Programs RS232C, Run DNC and Renumber Sequence Blocks.
These guys offer lots more now at great prices. Check them out the next time your looking for CAD/CAM or a good DNC Software.
http://www.g-zero.com/
Cheers
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com