[Delw]

Anyone have any info on how to wire this into the machine with the haas m-function cable?
There are spare m functions on one of the boards(1030 board? its the big board upper left corner), so a spare m-card doesnt look to needed.
I thought I read something a while back but couldnt find it again.

I have the control box and the hrt210 along with a cable from haas for m-functions.

Thanks In advance.
Delw

[denmar]

1060 (motherBoard) connect Black wire to TB1-7; White to TB1-13; (TB1 right top corner 1060); red TB3-1; green TB3-2 (TB3 is under cardcage botton right of 1060.
Also need 1050 M20/M21 Function Board at slot 16.

[Delw]

Denmar

I should be able to just use the 1060 card using the airbrake relay to send a signal.
I know about the 1050 card but the guy I use wont have them instock for a while.

I did end up putting it for now on the super max, using one relay had to put a dwell in the program but it works fine. Relay kicks on sends signal to box and gets it indexing.

If I am understanding this correctly the 1050 card in slot 16 is so you dont need to put a dwell in your program as it waits for a finished signal to the 4th axis controller before cutting?

[Waynno]

My solution to trigger the indexer, pretty simple, Buy a 12 volt relay, find an old
12v transformer that charges a battery or was for a similar task, Plug the transformer
in the mist coolant plug,

Use m7 & m9 and some creative dwell programming to trigger the Haas indexer

I know it does not sound too technical, but It has always worked here