Hi, I always have run the program serial go from a palm VII to load and recieve programs from my machines. I recently purchased a Palm Tungsten T, and I am having problems loading or receiving programs to or from the machine. The specific one is a fanuc zero T control. I recieve the error 085 communication error, and the palm freezes up. Can anyone help me out here.
Thanks, Adam
Results 1 to 4 of 4
-
11-14-2005, 08:20 PM #1
Registered
- Join Date
- Nov 2005
- Posts
- 2
Help... Fanuc ZeroT Communication error
-
11-14-2005, 08:39 PM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24220
If you are using a three wire serial cable, make sure the handshake is jumpered out on the Fanuc end, this often causes the 85 alarm.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
-
11-14-2005, 08:45 PM #3
Registered
- Join Date
- Nov 2005
- Posts
- 2
The handheld has a 16 pin hooked up to it, that ends with a 9 pin serial male which connects to a 9 pin female goes through a straight through cat-5 cable to a 25 pin into the machine.
-
11-14-2005, 09:13 PM #4
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24220
You might want to try a 9 pin to 25 pin cable that ends with 2,3 & 7 only, on the 25pin with 4-5 and 6-8-20 jumpered.
Depending on the software, you may need the 9 pin handshake jumpered also, which would be 7-8 and 6-1-4.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With Quote
Posting Permissions
