Hi everyone,
After sometime of trials and errors would like to ask your opinion and help to get this right.
I'm using 61991 Niagara cutter (representative recommendation for my material) on there web site I found data sheet for 304 steel, but cannot understand how to use it.
I have 0.022 inch steel plate where i do cut out.
My settings are:
Spindle speed: 1800 rpm
Feed: 10 inch/m
Depth per pass 0.0055 inch
Tool: 5 flute 1/4 diameter
For me it looks like feed is slow for this RPM, but I do not now what to adjust first.