[zaheer0047]

hi, am an architecture student interested to buy a Rabbit HX3040 and i was wondering if anyone could help me out. i was thinking about dividing a 3D design into a series of planes and gluing them together to get out a 3D.
what software can i use to do that? and if i got lest say a house 3D, any other oftware that break down all the planes so i can just cut it instead of measuring evrythg again and cutting plane by plane?
thx...
Zaheer0047

[p38nut]

I believe that Vectric's Cut3D will do what you want. You can try the trial version first to check it out.
Thanks. Mike

[p38nut]

[quote=zaheer0047;511091]
With that kind of attitude on this forum, I don't think you'll get much help. We pay with our hard earned dollars to get the best software available, not STEAL it!!!!

[Huahahahahaha]

better you open it with autocad.
then use "explode" command.

i think house 3D it'snot too complex.

[fractaledge3]

hi, am an architecture student interested to buy a Rabbit HX3040 and i was wondering if anyone could help me out. i was thinking about dividing a 3D design into a series of planes and gluing them together to get out a 3D.
what software can i use to do that? and if i got lest say a house 3D, any other oftware that break down all the planes so i can just cut it instead of measuring evrythg again and cutting plane by plane?
thx...
Zaheer0047

Hi zaheer,
Happy Eid.
Try the software in that link
http://www.tamasoft.co.jp/pepakura-en/

its a great one.

Osama

[zaheer0047]

hey soukran ya akri.... i didnt even knw we could do stuff like that:P lol.. thx a lot