603,884 active members*
5,089 visitors online*
Register for free
Login

Thread: Integrex 100-IISY C-Axis programming

Results 1 to 2 of 2
  1. 08-13-2008, 07:18 PM #1
    gsRAP
    gsRAP is offline Registered
    Join Date
    Aug 2008
    Posts
    2

    Integrex 100-IISY C-Axis programming

    I am trying to use the C axis for a part using EIA programming, but when it gets to the G12.1 line it gives a bad G code alarm. Without that G12.1 it runs through using the X and Y axis (until it runs out of travel).
    Here is the start of the sub program, which works on our Multiplexes:

    G98
    G12.1
    G17
    G90G0X-.0013Y-1.1765
    Z.1
    G1Z-.35F17.11
    Reply With Quote Reply With Quote
  2. 08-15-2008, 10:45 PM #2
    Integrexman
    Integrexman is offline Registered
    Join Date
    Aug 2006
    Posts
    62
    Make sure you are in T32 mode gcode. Parameter P16 bit3
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mazak Integrex 1060v8 c axis position errors
    By Bushman in forum Mazak, Mitsubishi, Mazatrol
    Replies: 0
    Last Post: 11-29-2007, 10:28 PM
  2. integrex 50 YB ISO Programming
    By Batman in forum G-Code Programing
    Replies: 3
    Last Post: 12-13-2006, 12:47 AM
  3. 4-axis, 3+2, or 4+ axis programming system?
    By roboticist in forum Uncategorised CAM Discussion
    Replies: 0
    Last Post: 09-04-2006, 07:02 PM
  4. integrex 200 II SY b axis wrong direction
    By smile in forum Mazak, Mitsubishi, Mazatrol
    Replies: 6
    Last Post: 06-07-2006, 05:09 AM
  5. 4 and 5 axis programming
    By Cammotion in forum G-Code Programing
    Replies: 1
    Last Post: 03-03-2005, 06:39 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules