Hi Everyone,
Recently I started to disassemble my 2001 vintage commercial 100 Watt laser cutter due to a software fault that could not be fixed.
I ordered new electronics from Sinjoe in China and finally they arrived yesterday. Who would have known that they would arrive with no information at all as to hope to connect everything together. I had earlier received a wiring diagram from Sinjoe, but it shows the AWC608 connected to Steppers. I am waiting for them to redraw it now to suit my configuration although I can't say how long that might take.

I did a lengthy search of the internet and found some probably useful documents, but unfortunately, they will only be useful to someone with a much higher level of electronics experience than I have.
Now I have every thing I need but with very little idea about putting it together. So, is there someone able to offer any help with the following components.

AWC708C Plus Controller.
HBS57 Easy Servo Drive and associated Easy Servo Motor.
RECI P16 LCD integrated Intelligent Protection Co2 Laser Power Supply.

I also have the necessary power supply (NES-350-36 ,with 36V ,9.7A and 350W.) for both Drives and for the AWC708C Controller (NES-75-24 ,with 24V ,3.2A and 75W).

I was told a long time ago, never be afraid to ask for help. So, here I am, asking for help.
Yes, I have also experienced the result of not asking when I should have.

I have the necessary cables to connect the Motors to the Drives. Unfortunately that is about all I would be sure of.

My Laser uses Optical Limit and Home switches so I will hope to retain them. It also had Servo motors, but all the internet found on them was a couple of adverts where they were for sale.

Here are a couple of photos of the new parts mentioned above.

I am retired and spend most of my time at my Son's workshop in Sunshine North in Victoria. If anyone is able to offer help and wants ti visit, they will be very welcome. Just send me a PM.

Thanks to all in advance.

Regards,
Albert