603,982 active members*
2,694 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Benchtop Machines > Looking to add a Aluminum Tooling Plate to my g0704

Thread: Looking to add a Aluminum Tooling Plate to my g0704

Results 1 to 2 of 2

Hybrid View

jhoffman@tftech Looking to add a Aluminum... 07-01-2013, 04:44 AM
Dylwad Cast aluminum and cast iron... 07-01-2013, 05:11 AM
  1. 07-01-2013, 04:44 AM #1
    jhoffman@tftech is offline Registered
    Join Date
    Jun 2013
    Posts
    4

    Looking to add a Aluminum Tooling Plate to my g0704

    I have a aluminum tooling plate for a X3 mill that I would like to use but I am not sure what problems I will run into with respect to galvanic corrosion because of the two different metals(Iron & Aluminum). The plate is cast aluminum with no anodizing on it.

    Will this be a big problem or will periodical cleaning take care of this issue?
    Reply With Quote Reply With Quote
  2. 07-01-2013, 05:11 AM #2
    Dylwad is offline Registered
    Join Date
    Dec 2004
    Posts
    783
    Cast aluminum and cast iron are pretty close to each other on a galvanic scale, suitable for contact under extreme (salt water) conditions. I think you will be fine on a mill. Maybe spray the surfaces with oil, silicone or grease before bolting together.

    Sent from tapatalk
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. G0704 Accessories and Tooling (non-cnc)
    By Fuelrush in forum Benchtop Machines
    Replies: 6
    Last Post: 09-20-2012, 02:53 AM
  2. MIC-6 3/4'' cast aluminum tooling plate!
    By QSPSB in forum Benchtop Machines
    Replies: 19
    Last Post: 12-17-2009, 05:26 AM
  3. Any tips for designing a fixture plate / tooling plate?
    By thackman in forum Benchtop Machines
    Replies: 9
    Last Post: 12-19-2008, 06:26 PM
  4. Aluminum: flat, bar, sheet, plate, tooling plate??????????
    By Dan S in forum DIY CNC Router Table Machines
    Replies: 12
    Last Post: 06-28-2007, 06:48 AM
  5. Discussion: Using aluminum tooling plate to build a bridge mill.
    By Deviant in forum Uncategorised MetalWorking Machines
    Replies: 2
    Last Post: 08-11-2006, 07:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules