[nlh]

Is it possible on an older M2 control to backup the parameters from the control to my laptop via RS-232? What about sending them back to the machine? I have to reinitialize the machine tomorrow and was looking for a quicker way rather than typing each value in. Any input would be appreciated.

Thanks

[CNCTECHNOLOGY]

Please looking for Mazak Camware software or Mazak Microdisk can help you

[nlh]

Well neither of those are an option at the moment. Is it not possible to use the same communication software I use to upload/download part programs to send/recieve the parameters?

Thanks

[CNCTECHNOLOGY]

Mazak M2 not same as Fanuc control only this way can upload and download part program and parameter by software. and microdisk

[nlh]

Ok thanks for your help.

[Rokkin]

Is this a Mazatrol M2 or an OKK M2?? I'm not sure if that was made clear. If it's a standard Mitsubishi M2 control you can download parameters, but a Mazak M2 requires special software.

[nlh]

Rokkin,

This is a Mazak M2.

Thanks