I would like to get info from someone who has installed and used the probe from improbe.
I have a 3 axis cnc with mach3 and vetric software.
I would like to know what do i have to do to get a scan of an object on my table
I would like to get info from someone who has installed and used the probe from improbe.
I have a 3 axis cnc with mach3 and vetric software.
I would like to know what do i have to do to get a scan of an object on my table
Don't know about Improbe but you may find this thread helpfull.
http://www.machsupport.com/forum/ind...ic,5004.0.html
I bought one & I'm getting good results.
Use either the probing wizard, or download and use the 3D probing plugin.
http://www.machsupport.com/plugins/Probing.m3p
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)