After lurking and reading for some some time, then buying a little Taig/Mach3 setup, this is my first post. I tried to find information regarding this on the cnczone site but I am not smart enough to search on the proper term.

Here's my setup...


In short its a Taig running the free Mach3 software.

Here the problem, Y & Z feed just fine. When using the keyboard to move the table, Y feeds @20 Units/Min and Z feeds @10.31 Units/Min. However X feeds then stops and buzzes. I can only move X while tapping the keyboard in short increments. Also, to guarantee no slipage I feed dog slow because of the X issue.

I think if I even new what the problem was called I could figure it out.

Whats the problem?

Thanks in advance. And in closing, I have to say, I have enjoyed reading posts and truly appeciate those who have taken the time to make this site informational beyond compare. Maybe as I learn I will be smart enough to do the same for others.