[Bluesman]

I have a Macro program that monitors spindle load, But I am sure it is only good for a 15I I am trying to set up my 16I's to do this but none of the paremeters I need to set are the same. Can anyonme tell me what the parrameters are to use this macro on a 16I
For exsample the par. to activate the macro is 913.6 on my 15I but the 16I 913 is not a 8 bit setting.

Bluesman

[Dan Fritz]

The parameter mapping in the 15 is totally different from the 16/18/21 series. The 15 parameter list is similar to the older Fanuc 10/11/12 series.

Sorry, can't help you on this one.

[Bluesman]

The parameter mapping in the 15 is totally different from the 16/18/21 series. The 15 parameter list is similar to the older Fanuc 10/11/12 series.

Sorry, can't help you on this one.

Yea, I kind of thought it was a big difrence, I just order a set of manuals from Fanuc. I should be able to figure it out with that I just thought I would get lucky and save some money. The sad thing is that I had a set of books for every one of the 28 machines we bought but that was three years ago and I have just been givin this department and low and behold nobody figured they were important enough to save

Bluesman

[Jarwalcot]

913.7 9933.7 {*/+=} Custom Macro B
913.6 9933.6 Interruption type custom macro

[Bluesman]

913.7 9933.7 {*/+=} Custom Macro B
913.6 9933.6 Interruption type custom macro

I got those what I am looking for is the parameters to configre a 9000 program that monitors the spindle load but enough about that I have an even larger question see the new thread

Bluesman