DEAR ALL HELPING FRIENDs,
I hv a HMC with M32 control.
Its magzine not rotating & alarm 389= Magzine over droop alarm appear.
Pl help
DEAR ALL HELPING FRIENDs,
I hv a HMC with M32 control.
Its magzine not rotating & alarm 389= Magzine over droop alarm appear.
Pl help
You may have a bad M/T controller
Hi,
Seems there is command for Magazine rotation, but no actual movement.
1) Magazine rotation is from Drive / Motor or Hydraulic? If Drive or Inverter / motor, which make Mitsubishi or Yaskawa or any other ?
2) Is there any slight movement of magazine? If not is the power cable of Magazine motor ok?
3) What is the status on Drive / Inverter?
Best Regards,
Girish