[cnc312]

hi friends.


we have MC-500H with osp5020M controller.
regarding APC shifter , I want to ask ;

how can we see the actual pos. , zero offsets of this shifter.

normally we can adjust act pos. of x,y,z,b with modifying zero ofsets and then set home positions, soft limits...

but for APC shifter (and also for ATC ) we coudn't see any act. pos. data.


I hope you understand what I mean


thanks.

[Superman]

Usually these positions are set when the machine is built or installed

The horizontal ( MX40-HA) we had, the pallet positioning was tied up with the G30 P(values)

where P1 was toolchange positioning, order was to go to the Z reference position first then X & Y position, with no movement in B
but the pallet #1 was G30 P3, & #2 was P4......yours may be along similar lines

Try "G30 P3" (or variations) in the MDI to see if it goes to one of the shuttle positions -----NOTE, turn rapids down, because if not set, the machine will go to XYZB home position ( usually the middle point of the table )

You can read the actual set values, but to change them, you need to enable the upper system areas, care is needed when editting in this area ( procedure long time ago, now forgotten)

[astral]

I think you want to see the position of the pallet because it did not meet the pallet

and for
chuck you want to change the tool orientation

right?

should go to section 2 of the parameters for this and there find positions and adjust them

[Algirdas]

it could be in machine axis parameters. Did you checked those?
can you access system (or machine system) parameters?

[cnc312]

please see attached pictures.

for x,y,z,b I can see act.pos. and can set the limits,home pos.

for apc shifter there are some parameters to set limits... but I don't know what it's act pos.

[astral]

in the first photo you have to position the pallet line 41 and line 36 to the previous page find compensation for pallets to stop correctly position
I guess that's what you want to adjust their position

After each change must click on
data load button to load the changes made