I have a Mori ZL25B with a MF-D6 controller, (Fanuc 16TT) I believe. I just had a RAM error; I did the Reset + Delete + On. I reentered all the parameters again by hand, and the PMC parameters that it would allow me to enter, but when I finished, I had an ex1047 alarm, I found out I did something wrong, and I was going to have to do it all over again.
I have found a few threads for different Fanuc controllers but not too much on the Fanuc 16TT. Not sure the order in which to start. It seems like it’s going to be a headache, but I would rather do it the right way, rather than guess and waste time.

Thank you in advance.