[mafitch7479]

Depending on how involved you want to get with this, I could suggest a way of moving some better parameters into your contouring parameter set. Are you prepared to have a bit of a tinker? It's all reversable if you don't find it helps.

Let me know the process, and the next time we do this project, I'll change them. We managed to finish the cuts, so we're moving onto a different project which won't require such high RPM's, or such a small cutter.

However, we'll have to do this project again in the near future, and probably do a similar cut on a smaller piece. I wish our machine went higher than 8000RPM, then I don't think we'd be having this problem.

[mafitch7479]

looks like this problem is coming up again, but this time using a 1/4" ball endmill at about 3000 RPM, so it must not be a high RPM problem. It cut out after about 2 hours of run time, cutting inversed domes for a vacuum form mold. We reset, started it from where it left off, and it happened again within a half hour.

Same error, "motion control queue runout detected in axis XYZ". The piece is about 10"x10"x0.5", with 25 domes cut into it. I wish I could figure out why the stupid machine is doing this to us!

[powerr]

i cannot remember off the top of my head how to do it. You need to load the naverror files onto usb and send it to hurco service. motion q errors are usualy software related. call hurco service 800 number and they will talk you through it.

[mafitch7479]

i cannot remember off the top of my head how to do it. You need to load the naverror files onto usb and send it to hurco service. motion q errors are usualy software related. call hurco service 800 number and they will talk you through it.

we made the log (press "alt-0" I think), and we'll have to call the Hurco guy again soon. He's been here a few times recently for this issue and hasn't been able to fix it apparently. He cleaned the board connections thinking that might be the problem, but I don't know if it was. Next time they bring him in, we'll have him pull the log file and send it to Hurco again. I believe he sent the file the last time it happened too.