[murfeedean]

:stickpoke

I have a multicam 3000 & I am getting a "motor error 23 xa, y, z" when I try to boot the machine up... The last thing it does is " enabling motor drives" before I get the error. I have moved the machine in all directions x, y & z & it does not seem to be in a bind so..... Please help if you can )

Thanks,
murfeedean
:cheers:

[CAD user 3000]

Did you find the cause of this error. I have the same problem?

[MCPservice]

1. Open up your control cabinet
2. Look at the 2 pole breaker in the bottom left hand side of the cabinet, has it tripped, if so reset the breaker and turn your machine on ....if the breaker trip when the drives go to enable...Then your bridge rectifier is bad and need to be replaced...

The 2 pole breaker is on the left side and is normally close to a large blue capacitor..sometimes the breaker is on the top row of components, next to a larger 3 pole breaker...my suggestion..post a pic of your control cabinet...

[jovanifive]

friends
I have a similar problem
or maybe worse
my keyboard I get an error
"Motor fault 23
xa
and
z
blink count 15
logic power backed up.
xb blink count 15
logic power backed up.
also I have multicam 3000
I can help
I'm in mexico
I appreciate any help