[pprasad]

Hi,

I have a Fanuc Robocut Alpha 1c W-EDM machine with Series 16W Controller, I'm looking for Operator manual, Operations manual, Parameters manual, Maintenance & Troubleshoot manual, Schematics manual.

Thank you,

[steryd]

I have operator's manual for a01B with the same control. Post an e-mail if U want.
As for schematics, i don't think fanuc gives this. I have parts manual, and there are some electrical circuits, but didn"t see anything more about that.

[pprasad]

Thank you very much for your reply. Please send all the manual's related to Alpha1C / Alpha 01B /16W Controller to this email id prasadinpti[@]gmail[dot]com. I must appreciate your kind reply, and thank you once again "Steryd"

[steryd]

i've sent all i have already scanned

[pprasad]

Thank you for your kind help, I must appreciate your support. Thank you once again...
Do you have Cutting Conditions manual

[gnani]

i've sent all i have already scanned

Hello,

I recently purchased a machine with a Fanuc Robocut Alpha 1c with Series 16W Controller.

I couldn't cut at all. I don't have the instructions. I would be grateful if you could share the information you have.

[email protected]

Best regards.

[steryd]

Thank you for your kind help, I must appreciate your support. Thank you once again...
Do you have Cutting Conditions manual

Yes, i have technology manual, but i have it only on paper. I planned to scan it anyway, but there was always something more urgent, hopefully in few days i'll manage to go to prontshop and make scans.

[steryd]

Hello,

I recently purchased a machine with a Fanuc Robocut Alpha 1c with Series 16W Controller.

I couldn't cut at all. I don't have the instructions. I would be grateful if you could share the information you have.

[email protected]

Best regards.

It's sent

[gnani]

It's sent

Thank you very much. I am glad you exist. I wish you good work.

[Jung]

Hi Steryd,

Can you send me a copy of this operator manual?
I have PMed my email.

Thanks,

[haguayo]

Hello Steryd, could you send me the manuals for the fanuc Robocut too please?
[email protected]

Thanks!

[Carlosek1]

Hello Steryd, could you send me the manuals for the fanuc Robocut too please?
[email protected]
Thanks