Aloha 'Aina!
My name is Patrick and I am new to this forum.
After looking for over 15 years, I fianlly found extrusion parts.....
from 80/20. And then I found this site.
I have very little machining experience. My father has a UniMatte Unilathe.
but my step threw it away when he dies before I had a chance to get it.
So, 25 years later I am looking to go again.
I did build an electric vehicle prototype for manufacture in Romulus Michigan
10 years ago.... But I just did the easy part - wiring the 120 volts....
Bob Sweat of MetalCraft Productions did al the hard stuff.
He never did CNC - he did it all himself. Among other tasks, he designed the tooling.
He was also the guy who invented "independent suspension" -
you know the upper and lower a-arm around the spring and strut...
But anyway - anyone here heard of him?
I would like more infor about him.... for my own knowledge.
that went to the factory