In Jan I got a table, machine, computer and software, all new. The plasma is a hypertherm powermax 85. Mach3 software. A Proma 150 THC.
I haven't been able to get it to work right yet. It was running the Z axis down no mater if I hit page up or page down. It would even drive down on its own randomly. After some work I somehow got it to work except for firing the plasma machine. It would run through a g-code fine.
Well the builder thought it was the computer chip in the control box. So he sent a new one and I installed it. But it's back to its old ways again. Except it's the x axis this time.. I'm so fed up with this thing. Please help if you can. Also as you can probably tell I'm not sure what most things are called. So any help with nomenclature is appreciated as well. Thanks